Tripped Breaker or Fuse in Wichita, KS
A breaker that trips once may have done its job after a surge or an overloaded circuit. A breaker that will not stay on, or one that trips every time you use an appliance, needs a closer look. Forcing a breaker to stay on, or putting in a larger fuse, is dangerous.
Free referral service. We connect you with an independent local electrician and do not do the work ourselves. Calls may be recorded.
Signs you may need help
- A breaker that trips as soon as you reset it
- A breaker that trips when a particular appliance or room is used
- A fuse that blows repeatedly
- An AFCI or GFCI breaker that will not reset
- A burning smell, heat or discoloration at the panel
What to do right now
- Reset a tripped breaker once: push it firmly to off, then to on. If it trips immediately again, leave it off.
- Unplug or switch off the devices on that circuit, then try one reset. If it holds, plug devices back in one at a time to see which load trips it.
- If the main breaker has tripped, or the panel is hot, buzzing or smells like burning, leave it alone and request a call-back. Call 911 if there is smoke or fire.
- Do not install a larger breaker or fuse so that it 'stops tripping,' and do not tape a breaker in the on position.
- If the house uses fuses, replace a blown fuse only with the same type and ampere rating.
In Wichita
A single trip after a storm or after a large appliance starts is not always a crisis. A breaker that will not stay on, or a panel that is hot or noisy, should be left alone until an electrician can inspect it.
What an electrician typically does
- Determine whether the trip is from an overload, a short, a ground fault, a failed breaker or a wiring problem
- Repair the cause, or replace a failed breaker with the correct type and rating
- Tell you if the circuit or the panel is no longer adequate for the load
- Give you a price before work starts, including any permit if a larger repair is needed
What actually happens depends on the electrician and on what they find when they get there.
Questions to ask before you agree to work
- Is the breaker itself failed, or is something on the circuit causing the trip?
- Are you replacing it with the same type and rating?
- If you recommend a panel or circuit upgrade, what would that involve and cost?
In Kansas, electrical licensing is typically handled locally by cities and counties rather than by one statewide board, so the license an electrician holds can differ between Wichita and the towns around it. Wichita Emergency Electrical is a referral service, not a licensed electrician or electrical contractor, and does not claim to be one. Always ask an electrician for their license number and the city or county that issued it, and confirm it before work begins.
In the Wichita area
We also refer people in these communities. Each page has local details for that neighborhood or suburb.
- Derby, KS
- Andover, KS
- Maize, KS
- Goddard, KS
- Haysville, KS
- Park City, KS
- Bel Aire, KS
- Valley Center, KS
- Mulvane, KS
- College Hill, KS
- Riverside, KS
- Delano, KS
- Old Town, KS
- Planeview, KS
- Linwood, KS
- West Wichita, KS
- Northeast Wichita, KS
See the full service area.
Common problems related to tripped breaker or fuse
Start here if you already know the symptom. Each page covers what to do right now and when it is an emergency.
- Power Out in Part of the HouseSome rooms or appliances have no power, while the rest of the house is on.
- Breaker Keeps TrippingA breaker trips again as soon as you reset it, or every time you use an appliance.
- GFCI Won't ResetA GFCI outlet or breaker will not stay reset, or a string of outlets is dead because of one.
See all common electrical problems in Wichita or the emergency electrician cost guide.
Other electrical problems
- Partial Power Outage
- Sparking Outlet or Switch
- Electrical Panel Problems
- Storm Electrical Damage
- Electrical Burning Smell